| Model: | HWIC-2CE1T1-PRI Cisco Router High-Speed WAN Interface card |
| Detail: | 2 port channelized T1/E1, and PRI HWIC (data only) Cisco Router High-Speed WAN Interface card |
Original price was: $5,800.00.$1,851.00Current price is: $1,851.00.
HWIC-2CE1T1-PRI Specification |
|
|
Description |
2 port channelized T1/E1, and PRI HWIC (data only) Cisco Router High-Speed WAN Interface card |
|
Diagnostic Loopback Support |
• E1 loopback modes: • Controller local loopback • Interface local loopback • T1 loopback modes: • Interface local loopback • Interface remote loopback • Controller local loopback • Controller remote loopback • CSU loopback modes for T1 CSU: • Data terminal equipment (DTE) loopback • Network loopback • Payload loopback |
|
Alarm Detection |
• Yellow Alarm-Receive/Send from/to network • Blue Alarm-Receive alarm indication signal (AIS) from network • Red Alarm-Loss of network signal |
|
Relevant MIB Support |
• T1 MIB (RFC1406-MIB) • Cisco Integrated DSU/CSU MIB (CISCO-ICSUDSU-MIB) |
|
Remote Management |
• Cisco CNS 2100 Series Intelligence Engine (IE2100) • CiscoWorks |
|
Signaling Debugging |
• ISDN Q.921 and Q.931 decode • All other previously existing applicable Cisco IOS Software debugs |
|
Dimensions (H x W x D) |
• HWIC-2CE1T1-PRI: 0.75 x 3.08 X 4.74 in. • (1.91 x 7.82 x 12.04 cm) |
|
Weight |
• HWIC-2CE1T1-PRI: 0.19 lb (0.09 kg) |
|
Operating Temperature |
• 32 to 104°F (0 to 40°C) |
|
Nonoperating Temperature |
• -40 to 158° F (-40 to 70°C) |
|
Relative Humidity |
• 5-95% noncondensing |
|
LEDs |
LEDs per port • Carrier Detect/Loopback (CD/LP): • Off = No carrier detect • Green On = Carrier detect • Yellow On = Port in loopback mode • Alarm (AL): • Off = No alarms • Yellow On = Port in alarm mode LEDs per module (on NM-8CE1T1-PRI only): • EN: • Off = Card not available • On = Card enabled |
|
Ports |
• 1, 2, or 8 T1/E1 ports on RJ-48C connectors |
|
Line Bit Rate (per Port) |
• E1: (2.048 Mbps) • T1: (1.544 Mbps) |
|
Line Coding |
• E1: High-density bipolar three (HDB3 ) • T1: Alternate mark inversion (AMI) and binary 8-zero substitution (B8ZS |
|
Framing Formats |
• E1: CRC4 • T1: Super Frame (SF) and Extended Super Frame (ESF) |
|
Output Levels |
• E1: short-haul/long-haul • T1 (line build-out [LBO]): 0, -7.5, or -15 dB |
Reviews
There are no reviews yet.